Filter
Top Products
43
90 DAYS
1. Remove lint from around basket (tumbler), drive motors, and surrounding areas.
2. Remove lint from gas valve burner area with a dusting brush or vacuum cleaner attachment.
3. Clean any lint accumulation in and around both the blower and drive motor casing openings.
NOTE: To prevent damage, avoid cleaning and/or touching ignitor/flame-probe assembly.
EVERY 6 MONTHS
Inspect and remove lint accumulation in customer furnished exhaust ductwork system and from dryers internal
exhaust ducting.
NOTE: THE ACCUMULATION OF LINT IN THE EXHAUST DUCTWORK CAN
CREATE A POTENTIAL FIRE HAZARD.
NOTE: DO NOT OBSTRUCT THE FLOW OF COMBUSTION and VENTILATION AIR.
CHECK CUSTOMER FURNISHED BACK DRAFT DAMPERS IN THE EXHAUST
DUCTWORK. INSPECT and REMOVE ANY LINT ACCUMULATION, WHICH CAN
CAUSE THE DAMPER TO BIND or STICK.
NOTE: A back draft damper that is sticking partially closed can result in slow drying and shutdown of
heat circuit safety switches or thermostats.
NOTE: When cleaning the dryer cabinet(s), avoid using harsh abrasives. A product intended for the
cleaning of appliances is recommended.
B. ADJUSTMENTS
7 DAYS AFTER INSTALLATION and EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws, (bearing setscrews), and non-permanent gas connections (unions, shutoff valves,
orifices, and grounding connections). Motor and drive belts should be examined. Cracked or seriously frayed
belts should be replaced. Tighten loose V-belts when necessary. Complete operational check of controls and
valves. Complete operational check of ALL safety devices (door switches, lint drawer switch, sail switch, burner
and hi-limit thermostats).
C. LUBRICATION
The fan shaft bearings should be lubricated every three (3) months. Use Shell Alvania grease NLGI grade 2 or
its equivalent. Generically, this grease would be described as an NLGI grade 2 multipurpose industrial grease
with a lithium thickener and mineral base oil. Lubrication is necessary. The motor bearings...and under normal/
most conditions the basket (tumbler) bearings are permanently lubricated. It is physically possible to re-lubricate
the basket (tumbler) bearings if you choose to do so even though this practice may not be necessary. Use Shell
Alvania grease NLGI grade 2 or its equivalent. Generically, this grease would be described as an NLGI grade 2
multipurpose industrial grease with a lithium thickener and mineral base oil. The basket (tumbler) bearings used
in the dryer DO NOT have a grease fitting. Provisions are made in the bearings housing for the addition of
grease fitting which can be obtained elsewhere.