Filter
Top Products
26
SECTION IV
OPERATING INSTRUCTIONS
A. STARTING THE DRYER
The dryer is available for use when the L.E.D. (light emitting diode) display reads “FILL” and/or the amount
needed to start the dryer (i.e., “25”). Once the load has been put into the dryer and the main door is closed, start
the dryer as follows:
1. Insert the proper number of coins into the coin acceptor. Once the correct “Amount To Start” has been
inserted, the L.E.D. (light emitting diode) display will read “PUSH” ... “tEnP.”
2. Determine fabric setting (selection). Setting “HI TEMP” is the high temperature range, “PERM PRESS”
is the medium temperature range, and “LO TEMP” is the low temperature range.
Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the
fabric setting key for the tumbler (basket) being used (i.e., “LO TEMP” setting for the upper tumbler
[basket]).
3. The dryer will now start, and the L.E.D. (light emitting diode) display for the tumbler (basket) selected will
read the setting and the time vended (i.e., “LO 10”).
4. The cycle time will count down until the drying and cooling cycles are completed.
5. Upon completion of the drying cycle and cooling cycle, the dryer will shut-off, the tone (buzzer) will sound
for five (5) seconds, and the L.E.D. (light emitting diode) display will read “donE.”
NOTE: If the Anti-Wrinkle program is active, the L.E.D. (light emitting diode) display will remain
reading “donE,” and the microprocessor controller (DMC) computer will proceed through the
Anti-Wrinkle program until the maximum “Active Guard Time” has expired or until the main
door is opened, whichever comes first.
NOTE: If the Anti-Wrinkle program is not active or in use, the L.E.D. (light emitting diode) display will
read “donE” until the main door is opened, at which time the L.E.D. (light emitting diode)
display will read “FILL” and/or the “Amount To Start.”
6. Notes
a. The dryer tumbler (basket) can be stopped at any time by opening the main door. To restart dryer, shut
the main door and press desired setting.
NOTE: When a cycle is interrupted by opening the main door, cycle time will continue to count
downward, regardless if the door is open or closed until a keyboard (touchpad) selection is
made.
b. Selection (setting) changes can be made at any time during the drying cycle by opening and closing the
main door and then making a new selection.