Filter
Top Products
17
If local codes permit, power to the dryer can be made by the use of a flexible U.L. listed power cord/pigtail
(wire size must conform to rating of dryer), or the dryer can be hard wired directly to the service breaker
panel. In both cases, a strain relief must be installed where the wiring enters the dryer.
Electrical Power Connection examples...
IMPORTANT: For a 120v installation, a two (2) wire service (L1 and Neutral) and a ground is
required (*). In the case of a 208v or 240v 1 phase service, three (3) wires (L1, L2
and Neutral) and a ground is required (*).
(*) For each tumbler/pocket.