Filter
Top Products
50
SECTION X
PROCEDURE FOR FUNCTIONAL CHECK OF
REPLACEMENT COMPONENTS
1. Microprocessor (computer) Board
a. Upon completing installation of the replacement microprocessor (computer) board, reestablish power to
the dryer.
b. Start the drying cycle.
c. Verify that the motor(s) and the heat indicator dots, in the microprocessor (computer) LED display are
on. (Refer to the illustration below.)
d. Verify that the motor(s) heat, and door indicator lights on the back side of the microprocessor (computer)
board are lit. (Refer to the illustration below.)