Filter
Top Products
39
Remove lint accumulation from around the openings in the dryer’s back panels.
Remove lint from gas valve burner train area with a dusting brush of vacuum cleaner attachment.
Remove any lint accumulation from the coin acceptor area, including the optical switch.
Inspect and remove lint accumulation in customer-furnished exhaust duct work system and from the dryer’s
internal exhaust ducting.
WARNING: THE ACCUMULATION OF LINT IN THE EXHAUST DUCT WORK CAN
CREATE A POTENTIAL FIRE HAZARD.
WARNING: DO NOT OBSTRUCT THE FLOW OF COMBUSTION AIR and
VENTILATION AIR.
Inspect and remove lint accumulation from the dryer’s exhaust duct work back draft dampers.
NOTE: A back draft damper that is sticking partially closed can result in slow drying and shutdown of the
heat circuit safety switches and/or thermostats.
6 MONTHS
In the cleaning of the dryer cabinet, avoid using harsh abrasives. A product for the cleaning of appliances is
recommended.
ALL bearings and set screws should be checked to insure they are tight.
B. Adjustments
7 Days After Installation and Every 6 Months Thereafter
Inspect bolts, nuts, screws (bearing set screws), non-permanent gas connections (unions, shut-off valves, ori-
fices, ect.), electrical terminals, and grounding connections.
Tighten loose belt(s) when necessary and check the alignment.
Inspect drive (motor/impellor [fan]) shaft belt. A cracked or seriously frayed belt(s) should be replaced. Tighten
loose belt(s) when necessary and check the alignment.
Complete operational check of controls and valves.
Complete operational check of ALL safety devices (door switches, lint compartment switches, sail switches,
burner and hi-limit thermostats).