Filter
Top Products
32
SECTION IV
OPERATING INSTRUCTIONS
A. Starting the Dryer
1. Coin Dryers
The dryer is available for use when the LED display reads “FILL” and/or the amount needed to start the dryer
(i.e., “25”). Once the load has been put into the dryer and the main door is closed, start the dryer as follows:
a. Insert the proper number of coins into the coin acceptor. Once the correct “Amount To Start” has been
inserted, the LED display will read “PUSH”.
b. Determine fabric setting (selection). Setting “HIGH TEMP” is the high-temperature range, “PERM
PRESS” is the medium-temperature range, and “LOW TEMP” is the low-temperature range.
Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the
fabric setting key desired (i.e., “LOW TEMP”).
c. The dryer will now start, and the LED display for the basket (tumbler) selected will read the setting and the
time vended (i.e., “LO 10”).
d. The cycle time will count down until the drying and cooling cycles are completed.
e. Upon completion of the drying cycle and cooling cycle, the dryer will shut-off, the tone (buzzer) will sound for
five (5) seconds, and the LED display will read “donE”.
NOTE: If the Anti-Wrinkle program is active, the LED display will remain reading “donE”, and the
Microprocessor Controller (computer) will proceed through the Anti-Wrinkle program until
the maximum “Active Guard Time” has expired or until the main door is opened, whichever
comes first.
NOTE: If the Anti-Wrinkle program is not active or in use, the LED display will read, “donE” until the
main door is opened, at which time , the LED display will read “FILL” and the “Amount To
Start”.
f. Notes
1) The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer, shut
the main door and press desired setting.
NOTE: When a cycle is interrupted by opening main door, cycle time will continue to count
downward, regardless if the door is open or closed, until a keyboard (touchpad) selection is
made.