Filter
Top Products
102
OUTPUTS:
1. R_HEAT – (GREEN L.E.D.) This light emitting diode (L.E.D.) will indicate the status of the rear
heat output. If the request to turn on the rear heater is made, then the
L.E.D. is ON.
2. AUDIO ALERT – (GREEN L.E.D.) This L.E.D. will indicate the status of the horn output. If the request
to turn on the horn is made, then the L.E.D. is ON.
3. FWD – (GREEN L.E.D.) This L.E.D. will indicate the status of the basket (tumbler) forward
direction output. If the request to tumble the drum in the forward
direction is made, then the L.E.D. is ON.
4. REV – (GREEN L.E.D.) This L.E.D. will indicate the status of the basket (tumbler) reverse
direction output. If the request to tumble the drum in the reverse
direction is made, then the L.E.D. is ON.
5. AIR JET – (GREEN L.E.D.) This L.E.D. will indicate the status of the air jet output. If the request
to turn on the air jet is made, then the L.E.D. is ON.
6. FAN – (GREEN L.E.D.) This L.E.D. will indicate the status of the fan output. If the request to
turn on the fan (blower) is made, then the L.E.D. is ON.
7. F_HEAT – (GREEN L.E.D.) This L.E.D. will indicate the status of the front heat output. If the
request to turn on the front heater is made, then the L.E.D. is ON.
8. PGR1 – (GREEN L.E.D.) This is for a spare output to be programmed.
9. PGR2 – (GREEN L.E.D.) This is for a spare output to be programmed.
10. PGR3 – (GREEN L.E.D.) This is for a spare output to be programmed.
11. PGR4 – (GREEN L.E.D.) This is for a spare output to be programmed.
12. OCL1 – (GREEN L.E.D.) This L.E.D. will indicate the status of the open collector output #1. If
the request to turn on the open collector output #1 is made, then the
L.E.D. is ON. (Programmable and defaulted to front door open).
13. OCL2 – (GREEN L.E.D.) This L.E.D. will indicate the status of the open collector output #2. If
the request to turn on the open collector output #2 is made, then the
L.E.D. is ON. (Programmable and defaulted to front door closed).
14. OCL3 – (GREEN L.E.D.) This L.E.D. will indicate the status of the open collector output #3. If
the request to turn on the open collector output #3 is made, then the
L.E.D. is ON. (Programmable and defaulted to lint drawer).
15. OCL4 – (GREEN L.E.D.) This L.E.D. will indicate the status of the open collector output #4. If
the request to turn on the open collector output #4 is made, then the
L.E.D. is ON. (Programmable and defaulted to front down).