Filter
Top Products
100
INPUTS:
1. FDRC – (RED L.E.D.) This light emitting diode (L.E.D.) will indicate the status of the front doors. If the
doors are closed, then the L.E.D. is ON.
2. FDRO – (RED L.E.D.) This L.E.D. will indicate the status of the front doors. If the doors are open, then
the L.E.D. is ON.
3. TBOL – (RED L.E.D.) This L.E.D. will indicate the status of the basket (tumbler) overload contact. If
the contact is closed, then the L.E.D. is ON. If it faults open, then the L.E.D. is
OFF.
4. FNOL – (RED L.E.D.) This L.E.D. will indicate the status of the fan overload contact. If the contact is
closed, then the L.E.D. is ON. If it faults open, then the L.E.D. is OFF.
5. RDWN – (RED L.E.D.) This L.E.D. will indicate the status of the rear tilt. If the rear of the dryer is down,
then the L.E.D. is ON.
6. FDWN – (RED L.E.D.) This L.E.D. will indicate the status of the front tilt. If the front of the dryer is
down, then the L.E.D. is ON.
7. RDRC – (RED L.E.D.) This L.E.D. will indicate the status of the rear doors. If the doors are closed, then
the L.E.D. is ON.
8. RDRO – (RED L.E.D.) This L.E.D. will indicate the status of the rear doors. If the doors are open, then
the L.E.D. is ON.
9. FAN – (RED L.E.D.) This L.E.D. will indicate the status of the blower fan. If the fan is on, then the
L.E.D. is ON.
10. RBHL – (RED L.E.D.) This L.E.D. will indicate the status of the rear burner high limit disk. If the disk is
closed (temperature below 330º F [165º C]), then the L.E.D. is ON.
11. R_SS – (RED L.E.D.) This L.E.D. will indicate the status of the rear sail switch. If the switch is closed,
then the L.E.D. is ON.
12. FBHL – (RED L.E.D.) This L.E.D. will indicate the status of the front burner high limit disk. If the disk
is closed (temperature below 330º F [165º C]), then the L.E.D. is ON.
13. F_SS – (RED L.E.D.) This L.E.D. will indicate the status of the front sail switch. If the switch is closed,
then the L.E.D. is ON.
14. EXHL – (RED L.E.D.) This L.E.D. will indicate the status of the exhaust high limit disk. If the disk is
closed (temperature below 225º F [107º C]), then the L.E.D. is ON.
15. DRY – (RED L.E.D.) This L.E.D. will indicate the status of the programable logic controller (PLC). If
the mechanical functions of the dryer have been set to the DRY position, the PLC
will send a signal to the Phase 7 board. This signal will indicate that ALL the
doors are closed and the dryer is level. When these conditions are met, then the
L.E.D. is ON.