Filter
Top Products
26
IMPORTANT: If the blower wheel (impellor/fan) is rotating in the wrong direction, this will not only
drastically reduce drying efficiency, but it can also cause premature component failure.
J. PREOPERATIONAL INSTRUCTIONS
1. Coin Models
a. Microprocessor
1) When turning on power or when no cycle is in progress, light emitting diode (L.E.D.) display will
read “FILL” and/or “Amount to Start” (i.e. “25”).
2) Insert coin(s). Once correct “Amount To Start” has been inserted the display will read “PUSH.”
3) Select temperature by pushing “HI TEMP,” “LO TEMP,” or “PERM PRESS.” The dryer will start
and the L.E.D. display will read the temperature cycle selected and the drying time.
4) The dryer will continue through the drying and cooling cycles, showing time counting downward.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count down in time. Continuation of the
cycle will resume only after the door has been closed and any of the three (3) temperature
selection buttons is again depressed.
5) Upon completion of drying and cooling cycles, the tone (buzzer) will sound for 5-seconds, and the
L.E.D. will read “donE,” at which time the dryer will shutoff.
NOTE: If the Anti-Wrinkle program is active, the L.E.D. display will continue to read “donE,” and the
microprocessor controller (computer) will proceed through the Anti-Wrinkle program until the
maximum “Active Guard Time” has expired or until the door is opened, whichever comes first.
The L.E.D. display will read “FILL” and/or the “Amount To Start” (i.e. “25”).
b. Rotary (mechanical) coin meter:
1) Insert coin into coin acceptor and turn the knob to the right (->).
2) Select “HI TEMP” on the rocker switch.
3) Push the “PUSH to START” switch.
4) The dryer will start and will continue through the drying and cooling cycles until the time vended has
expired.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the coin
meter will continue to count down in time. Continuation of the cycle will resume only after the
door has been closed and the “PUSH to START” button is again depressed.