Filter
Top Products
32
To Replace Rear Idler Shaft Pillow Block Bearing
1. Follow steps 1 through 3 from "To Replace Front Idler Shaft Bearing".
2. Remove retaining rings on each side of forward idler shaft pillow block bearing.
3. Loosen the two (2) set screws on each bearing collar.
4. Slide both bearings off the shaft.
5. Replace by reversing procedure.
NOTE: Replacement idler shaft is now manufactured with a hump on the shaft therefor no
retainings are needed.
6. Reestablish power to dryer.
I. V-Belts (See illustrations in section F "Pulleys")
V-belts should have proper tension. If too loose, they will slip, excessive wear on the bearings will result. If the
pulleys are not properly aligned, excessive belt wear will result. Proper belt tension will allow 1/2" displacement
under normal thumb pressure at mid span of belt.
NOTE: Belts must always be replaced in pairs (matched sets).
V-Belt Tension Adjustment (Basket to Idler)
1. Discontinue power to dryer.
2. Back off jam nuts on idler adjustment belts.
3. Tighten belts by turning both bolts evenly clockwise. (Turn clockwise to loosen belts.)
4. Check vertical plane of idler pulley for parallel alignment with basket pulley.
5. If realignment is required, loosen basket pulley and bushing, and move basket pulley to proper
position.
6. Retighten jam nuts.
7. Reestablish power to dryer.