Filter
Top Products
24
IMPORTANT: Under no circumstances should the door switch be disabled.
To Replace Main Door Assembly
1. Remove screws holding main door to main
door hinge pad.
2. Reverse this procedure for reinstalling new
main door assembly.
To Install New Main Door Glass
1. Remove main door assembly from dryer
(follow main door removal procedure).
2. Lay main door on flat surface with front
of door face down.
3. Remove glass and clean all old sealant off
main door. This area must be completely
cleaned for correct bonding.
4. Apply a narrow bead of silicone (ADC P/N 170730) all around main door area where glass will rest.
5. Install glass onto door/adhesive and slightly press glass in place.
IMPORTANT: DO NOT press hard or silicone thickness between the glass and door will be
reduced, resulting in poor bonding.
6. The door assembly should now be put in an area where it will not be disturbed for at least 24 hours. Depending
on the conditions, the curing time of this adhesive is 24 to 36 hours.
7. After 24-hour curing period, install main door on dryer by reversing step 1.