Filter
Top Products
Instructions for use
28
Wash cycle ended/Remove washing
After the wash programme has been ended, END (EINDE, FIN) is dis-
played on the Programme cycle display.
• If programme EASY IRON (STRIJKVRIJ, SANS REPASSAGE) has been
selected, then a crease guard programme of ca. 30 minutes is carried
out after the programme end. The multi-display then additionally
shows a rest time of 1 minute and the display END (EINDE, FIN) lights
up. During the crease guard programme, the door can be opened at
any time and the washing can be removed.
• If RINSE STOP (GEEN CENTR., SANS ESSOR.) has been selected, the
display next to the
START/PAUSE (START/PAUZE, MARCHE /PAUSE) button blinks.
0 1. After a rinse stop, the water must first be pumped out:
– Either press the START/PAUSE (START/PAUZE, MARCHE /PAUSE) but-
ton (water is pumped out and the washing is spun according to the
position of the programme; with the RINSE STOP (GEEN CENTR.,
SANS ESSOR.) spin speed, the speed of spinning can also still be
changed during spinning),
or
– Turn Programme knob to PUMP (POMPEN, VIDANGE) and press the
START/PAUSE (START/PAUZE, MARCHE /PAUSE) button (the water is
pumped off without spinning),
or
– Turn programme knob to SPIN (CENTRIFUG., ESSORAGE) or SHORT
SPIN (KORT CENTRIFUG., ESSORAGE DELICAT) and press START/PAUSE
(START/PAUZE, MARCHE /PAUSE) button (water is pumped out and
the washing is spun or short spun).
After the end of this programme step, the END (EINDE, FIN) display
lights up.
2. Open filling door.
As soon as the display next to the DOOR/LIGHT (DEUR/LICHT, PORTE/
ECLAIR.) lights green, the door can be opened (not when the pro-
gramme security is activated. For this see „Programme security„).
3. Remove washing.
4. Turn programme knob to OFF (UIT, ARRET).
5. After washing, pull the washing agent drawer out a little so that it can
dry out. Lean door only against frame do that the washingmachine can
vent out.