Filter
Top Products
Operating Instructions
35
Washing is not well
spun. Residual water is
still visible in the drum.
Error code
(2 is shown
in the multi-display.
Drainage hose bent. Remove the bend.
Maximum pumping height
(discharge height 1m from
the unit's standing surface) is
exceeded.
Contact your customer serv-
ice. For pumping heights
over lm he can offer you a
conversion kit as a special
accessory.
Drain pump is blocked.
Switch off the unit and pull
out the mains plug. Clean
the drain pump.
If a siphon is connected: Si-
phon blocked.
Clean the siphon.
The main door cannot
be opened while the
appliance is turned on.
The filling door is locked be-
cause of a high water level or
a high temperature. The
DOOR indicator lights red.
Wait until the DOOR indica-
tor lights up green.
Should it nevertheless be
necessary to open the main
door:
Turn the programme knob to
OFF; turn the programme
knob to PUMP OUT. Press
button START/PAUSE. The
main door can be opened af-
ter the water has been
pumped out.
Power failure!
(All indicators have gone
off.)
For safety reasons the door
remains locked for 4 to
10 minutes.
If water can be seen through
the window in the door, first
carry out emergency empty-
ing (see section “Carrying out
Emergency Emptying Opera-
tion").
After approx. 4 to 10 minutes
the door can be opened
again by pulling the handle.
Remnants of detergent
are building up in the
detergent drawer.
Water tap not fully opened. Open the water tap fully.
Filter in the screw connec-
tion of the intake hose on
the water tap or on the unit
is blocked.
Close the water tap. Unscrew
the inlet hose from the water
tap and from the unit and
clean the filter.
Problem Possible Cause Remedy