Filter
Top Products
Operating Instructions
24
Starting the washing program
0 1. Check that the water tap is open.
2. Start the washing program:
Press the START/PAUSE button
The washing program is started or starts at the
end of the time delay set.
3
The door is not correctly closed if, when the button START/PAUSE
is pressed,
– the error code Cd is shown in the multi-display and
– the indicators PRE WASH, RINSE and RINSE+ flash
In this case, press the door firmly closed and again press the
START/PAUSE button.
If the delay timer has been set:
The start time delay set on the time delay counts down; the time
remaining until the program starts is displayed in the multi-display
(in hours remaining, e.g. 5h). During this time you can add washing and
change or stop the delay timer.
• Load the washing: Press the START/PAUSE button. The door can be
opened. Then close the door and press the START/PAUSE button
again.
• Changing or stopping delay timer: Press the DELAY TIMER button re-
peatedly until the desired time is displayed. When the program dura-
tion is displayed (display in minutes e. g.120) the washing program
starts without delay.