Filter
Top Products
Operating Instructions
26
Wash cycle complete/removing the washing
When a wash programme is complete:
When a wash programme has come to an end, END is illuminated in the
programme progress display.
0 3. Open the door.
As soon as the DOOR indicator shows green, the door can be opened.
4. Remove the washing.
5. Turn the programme selector to OFF .
6. After the wash, pull out the detergent drawer slightly to allow it to dry.
Leave the door slightly open to allow the inside of the washing ma-
chine to air.
If RINSE HOLD was selected:
If a programme finishes with RINSE HOLD, the indicator next to the
START/PAUSE button will flash.
0 1. After a rinse hold, the water must first be drained:
– Press either the START/PAUSE button
(the water is drained and the washing is spun in accordance with the
finished programme; the number of spin revolutions can still be al-
tered during the spin cycle using the spin revolution/RINSE HOLD
button),
or
– Turn the programme selector to OFF, and then to PUMP, and press the
START/PAUSE button
(the water will be drained without the spin cycle taking place),
or
– Turn the programme selector to OFF, and then to SPIN or SHORT SPIN,
and press the START/PAUSE button
(the water will be drained and the washing is spun or briefly spun).
After this programme cycle is complete, the END indicator illuminates.
The wash programme is complete.
2. Open the door and remove the washing.
3. Turn the programme selector to OFF.
If the EASY IRON programme was selected:
With EASY IRON, a crease prevention cycle of approx. 30 minutes takes
place after the programme is complete. The multi-display shows the
time remaining (e.g. 1 minute) and the END indicator iluminates.
You can remove the washing at any time during the crease prevention
cycle.