Filter
Top Products
Operating Instructions
33
Water is not running.
Error code
(1 is shown
in the multi-display.
Water tap closed. Open the water tap.
Filter in screw connection of
the intake hose blocked.
Close the water tap. Unscrew
the hose from the tap, re-
move the sieve and clean un-
der running water
Water tap is blocked with
limescale or is faulty.
Check water tap and have it
repaired if necessary.
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The transport packaging has
not been removed.
Remove transport packaging
according to the installation
and connection instructions.
The height-adjustable screw
feet are not correctly set.
Adjust the feet in accordance
with the installation and
connection instructions.
There is not much washing in
the drum (e.g. only one
dressing gown).
This does not impair the
function.
The water could not be com-
pletely pumped off before
spinning because
The drainage hose is bent
or
The drain pump is blocked.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the drain pump and, if
required, remove foreign
bodies from the pump hous-
ing.
The washing solution
of the main wash
froths up a lot.
Too much detergent was
probably used.
Meter the detergent exactly
in accordance with the man-
ufacturer's information.
Problem Possible Cause Remedy