Filter
Top Products
Operating Instructions
24
The washing cycle is finished/Remove the washing
After a washing program has ended, L (END) lights up on the program
sequence display.
If o (RINSE HOLD) was selected, the display next to the O/s (START/
PAUSE) button flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– Either press the O/s (START/PAUSE) button (the water is pumped
off the and the washing is spun according to the finished program;
After the O/s (START/PAUSE) button is pressed again, the spin
speed can still also be changed during spinning), or
– Turn the program selector to C (PUMP OFF) and press the O/s
(START/PAUSE) button (the water is pumped off without spinning),
or
– Turn the program selector to D (SPIN) or F (SHORT SPIN) and press the
O/s (START/PAUSE) button (the water is pumped off and the wash-
ing is spun or gently spun).
After the end of this program step, the L (END) indicator will illumi-
nate.
2. Open the filling door.
As soon as the
K
(DOOR) indicator lights up green, the filling door can
be opened.
3. Remove the washing.
4. Turn the program selector to I (OFF).
5. Close the water valve.
6. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3
If the indicator Å (OVERDOSING) lights up, too much deter-
gent was used in the washing program just ended. Observe the
dosing recommendations of the detergent manufacturer as well as the
filling quantity for the next wash.
Important! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.