Filter
Top Products
18
ACCUMULATIVE TIME (AtIn)
(
SINGLE COIN)
In this program mode (“AtIn”), each coin inserted has a specific value in time which is determined by the “Time
For Amount To Start” (“tFAS”) program (PL11).
Example No. 1: If the dryer is equipped with a 25¢ coin acceptor and the desired time is 30 minutes, each
additional coin inserted would yield 30 minutes.
Settings: PL09 (LCdE)........................25
PL11 (tFAS) ..........................30
PL12 (AtSt) ...........................25
Example No. 2: If the dryer is equipped with a 25¢ coin acceptor and the “Amount To Start” (“AtSt”) is 50¢
for 30 minutes, the insertion of each additional coin would yield 15 minutes. In this application
the “Time For Amount To Start” (“tFAS”) is determined by a Phase 5 coin microprocessor
controller (computer) calculation. There is no calculation required by the owner.
Formula: (LCdE/AtSt) (tFAS) = Vended Time for “ LCdE” (25¢/50¢) (30) = 15 minutes
Settings: PL09 (LCdE)........................25
PL11 (tFAS) ..........................30
PL12 (AtSt) ...........................50
(DUAL COIN)
In the accumulative time (AtIn) mode, when using a dual coin acceptor, once the “Amount To Start” (“AtSt”)
has been inserted, the addition of a coin(s) yields more time. The amount time accumulated for each additional
coin inserted is determined by the “Time For Amount To Start” (“tFAS”) program (PL11).
The “Time For Amount To Start” (“tFAS”) is determined by a Phase 5 coin microprocessor controller (computer)
calculation of additional amounts installed.
Formula: (LCdE/AtSt) (tFAS) = Vended Time
Example No. 1: Using a 10¢/25¢ dual coin acceptor with the desired “Amount To Start” (“AtSt”) being 25¢
for 15 minutes, each additional 10¢ would yield the following:
Formula: (LCdE/AtSt) (tFAS) = Vended Time for “LCdE” (10¢/25¢) (15 minutes) 6 minutes
Settings: PL09 (LCdE)........................10
PL10 (rCdE) .........................25
PL11 (tFAS) ..........................15
PL12 (AtSt) ...........................25