Filter
Top Products
11
B. AUTOMATIC MODE (PATENT NO. 4,827,627)
1. When turning on power or when no cycle is in progress, the light emitting diode (L.E.D.) display will read
“FILL” and/or “Amount To Start” (“AtSt”).
2. Insert coin(s). Once correct “Amount To Start” has been inserted, the L.E.D. display will read “PUSH.”
3. Select temperature by pushing “HI TEMP,” “LO TEMP,” or “PERM PRESS.” The dryer will start, the
L.E.D. display will read the temperature cycle selected, and the drying time portion of the L.E.D. display
will read “00” and count upward as time elapses.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the Phase 5
coin microprocessor controller (computer) will continue to count upwards in time.
Continuation of the cycle will resume only after the door has been closed and any one (1) of
the three (3) temperature selection buttons is again depressed.
4. Once the preprogrammed dryness level and cool down period have been reached or maximum automatic
time has expired, whichever comes first, the buzzer (tone) will sound, and the L.E.D. display will read
“donE” for 5-seconds, at which time the dryer will shut off.
NOTE: If the Anti-Wrinkle Program is active (“Grd”), the L.E.D. display will remain reading “donE,”
and the Phase 5 coin microprocessor controller (computer) will proceed through the
Anti-Wrinkle Program until the maximum “Guard On Time” has expired or door is opened,
whichever comes first. The L.E.D. will read “FILL” and/or “Amount To Start” (“AtSt”).
NOTE: If the Anti-Wrinkle Program is not active (“nGrd”), the L.E.D. display will read “donE” until
the main door is opened, at which time the L.E.D. display will read “FILL” and/or “Amount To
Start.”