A SERVICE OF

logo

Open as PDF
next previous
When The Misfeed IndicatorLights
TROUBLESHOOTING
“:% + G “ Paper misfeed in the paper exit section
1.
Remove the misfed
paper.
~ Open thetopcoverorpaperdelivery fence
if it is necessary.
2. Press the Reset key.
— To prevent paper misfeed:
#Check the position of the paper delivery rollers. See page 18.
ClIf the exit sensor is dim with paper dust, clean it. See page 41.
~ If there is a Iar e solid fill image on the leading edge of the original, set the original
3
so that its lea mg edge becomes the trailing edge. Altemativel , change the Image
J
position and make a margin of more than 5 mm, 1/5” at the lea ing edge of prints.
IJ Try to change the printing speed.
~ When you set a curled paper, mrrect the face curl of the leading edge of the
paper as shown below.
-FeedDirection
53