Thermal Head
DAILY MAINTENANCE
4.
While pushing out the platen roller
release levers (located on both sides
of the feed roller),
grip both ends of the
feed roller and lift it straight up.
5.
Clean the thermal head as follows:
(1) Wipe the surface of the thermal head with a
damp cloth.
(2) Clean the surface ofthe thermal head several
times using the cleaner pen with cleaning
solution. (The cleaner pen is stored in the
carton box as an accessory.)
(3) Dry the surface of thermal head with a clean
dry cloth.
~ Make sure to put the cap back onto the
cleaning solutionbottle.
~ Replace the felt of the cleaner pen if it
becomes dirty.
6.
Grip the platen roller release levers,
and put the feed roller back in its
original position. While pushing
the right platen roller release lever
strongly until it is set completely, set
the platen roller release levers in its
original position.
7.
Place the master roll back in its original position. See page 6.
37
