5-16
Message Cause Solution
The media jam occurs. Remove the media and reset it.
The media width has not been
detected correctly.
Check the media set position. ( P.2-
8)
Clean the media sensor. ( P.4-4)
A HDC position counter error
occurred.
Turn off the main power to the
machine and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
Y-origin could not be detected.
Abnormal linear scale.
The media is set outside the proper
area.
Check the media set position. ( P.2-
8)
The liquid level sensor abnormality
of the damper has been detected.
Turn off the main power to the
machine and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
Though a certain amount was con-
sumed, there is no change in the
damper sensor High.
Perform “DAMPER ( P.5-6) ” of the
maintenance.
Even if you performed this, when the
message is displayed, contact your
local distributor to call for service.
Though a certain amount was con-
sumed, there is no change in the
damper sensor Low.
Overflow from the damper has been
detected.
Ink could not be supplied to the
damper.
Perform “DAMPER ( P.5-6) ” of the
maintenance. Also check the remain-
ing amount of ink in the Eco-cartridge.
Even if you performed this, when the
message is displayed, contact your
local distributor to call for service.
ERROR 50c
MED I A WI DTH SENSOR
ERROR 516
MED I A SET POS I T I ON R
ERROR 516
MED I A SET POS I T I ON L
ERROR 617
DAMPER Sens:12345678
ERROR 618
DAMPER/HIGH:12345678
ERROR 619
DAMPER/LOW :12345678
ERROR 61a
INKOver f low:12345678
ERROR 61b
SUPPLY INK :12345678
