Warning / Error Messages
5-15
1
1
1
1
5
Troubleshooting
Message Cause Solution
An error occurred in the main PCB
3.3VB power supply.
Turn off the power to the machine and
turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
COM driver becomes the high tem-
perature.
New Print Head was recognized.
The main PCB Q6 is disabled (short
mode).
An error is detected on the wave-
form printed on.
An error occurred in the main PCB
V_CORE power supply.
An error occurred in the main PCB
1.5VB power supply.
An error occurred in the main PCB
12V power supply.
The machine received some data
other than command data.
Securely connect the interface cable
in position.
Use an interface cable conforming to
the specifications.
Any parameter outside the range of
acceptable numeric values was
received.
A maintenance command error
occurred.
USB device initialization failure.
Turn off the main power to the
machine and turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
Occurrence of a time out error on a
USB device.
An excessive load was applied to
the X motor.
An excessive load was applied to
the Y motor.
An error due to an excessive cur-
rent of the X motor was detected.
An error due to an excessive cur-
rent of the Y motor was detected.
ERROR 16e
Ma i n PCB V3R3B
ERROR 171
NEW HEAD CONNECT
ERROR 172
Ma i n PCB Q6 Check K
ERROR 18
a
Ma i n PCB V_CORE
ERROR 18b
Ma i n PCB V1R5B
