Connecting the Machine
26
1
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Effec-
tive].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed. If
both ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
terface takes precedence.
❒ When [POP before SMTP] is set to [On], also make setting for [Reception Protocol]
and [POP3/IMAP4 Settings].
❒ When setting [POP before SMTP] to [On], check [POP3] port number in [E-mail
Communication Port].
Reference
p.54 “Interface Settings”
p.63 “File Transfer”
Settings Required to Use Scan to Folder Function
This section lists the settings required for sending file.
Ethernet
This section lists the settings required for sending file with ethernet cable.
For details about how to specify the settings, see “Interface Setting” and “File
Transfer”.
File Transfer Setting Reception Protocol As required
File Transfer Setting POP3/IMAP4 Settings As required
File Transfer Setting Key Operator's E-mail Add. As required
File Transfer Setting E-mail Communication Port As required
File Transfer Setting Scanner Resend Time As required
File Transfer Setting Scanner Resend Setting As required
Menu User Tool Setting Requirements
Interface Setting/Network Machine IPv4 Address Necessary
Interface Setting/Network IPv4 Gateway Address Necessary
Interface Setting/Network DNS Configuration As required
Interface Setting/Network DDNS Configuration As required
Interface Setting/Network Domain As required
Interface Setting/Network WINS Configuration As required
Interface Setting/Network Effective Protocol Necessary
Interface Setting/Network LAN Type Necessary
Menu User Tool Setting Requirements
