Basic Procedure
41
2
E
Adjust the paper guides to the paper size.
1.
Horizontal size
2.
Vertical size
3.
Extender
4.
Paper guides
Note
❒ Make sure the paper size and direction in the bypass tray is displayed on
the operation panel.
❒ Make sure that the paper guides matches to the paper size. If the paper
guides are not adjusted to the paper size properly, paper might be skewed
or a paper misfeed might occur.
❒ With large copy paper (more than A4L, 8
1
/
2
" × 11"L), swing out the ex-
tender.
F
With the side you wish to copy onto face up, insert the paper into the by-
pass tray until it stops.
G
Set your originals, then press the {
{{
{Start}
}}
} key.
Copying onto custom size paper with the bypass tray
Preparation
You can register custom paper sizes you use often in keys [Custom 1], [Custom
2], and [Custom 3] with the user tools. ⇒ P.175 “System settings”.
Note
❒ Be sure to set the paper size or a paper misfeed might occur.
A
Open the bypass tray.
B
Press the [Normal], [Thick] or [OHP] key.
C
Press the [K
KK
K/L
LL
L] key to select paper orientation.
TRSH050E
1
3
2
4
Trsh050e.eps
