Changing the Machine's Settings
176
6
Control Panel Off
Level
The machine enters Energy Saver Mode automatically after your job is
finished.
Three Energy Saver levels are available.
• Level 1
The back light of the panel display goes off.
Warm-up time: 0 seconds
• Level 2
Power consumption approximately A 25% decrease compared to
stand-by.
Warm-up time: Approximately 80 seconds
• Level 3
Power consumption: Approximately A 50% decrease compared to
stand-by.
Warm-up time: Approximately 140 seconds
Note
❒ Default: Level 1
System Reset Timer
(Printer Option Re-
quired)
The machine returns to its prioritized mode automatically a certain
time after your job is finished, after the selected time. The time can be
set from 10 to 990 seconds (in 10 seconds steps), or off.
Note
❒ Default: On (60 seconds)
Function Reset Timer
(Printer Option Re-
quired)
When Interleave Print is turned on and a print job comes along while
the machine is busy printing another job, this delay specifies how long
the machine will wait before switching to the priority print job.
The time can be set from 10 to 990 seconds.
Note
❒ Default: On (60 seconds)
❒ The optional printer is required to use this function.
Tray Paper Size Select the size of the copy paper set in the paper tray.
Note
❒ If the specified paper size differs from the size of paper actually set
in the paper tray, a paper misfeed might occur because the paper
size is not detected correctly.
Reference
For details, ⇒ P.197 “Mainframe”.
Paper Tray Priority You can select the paper tray which will be selected as a default in the
following conditions:
• When the main power switch or operation switch is turned on.
• When System Reset or Auto Reset mode is turned on.
• When the {Clear Modes} key is pressed.
• When the Auto Paper Select mode is not selected.
Note
❒ Default: Tray 1
Menu Description
