A SERVICE OF

logo

Open as PDF
next previous
2001 Pontiac Aztek 1-35
Rail Sectioning—
Rear
Installation Procedure
1. Mark the cut location on the service
rail by measuring 5 mm (1/4 in.)
from the front edge of the second
gauge hole forward.
2. Cut the rear rail service part.
3. Cut and remove 30 mm (1 and 3/16
in.) from the flanges on either side
of the service section rail to create
30 mm (1 and 3/16 in.) tabs (1).
4. Cut 5 mm (1/4 in.) wide gaps in the
bottom corners (2).
5. Step the tabs inward (1) to allow the
service rail section to fit inside of
the original rear rail.
IMPORTANT: The metal of the rear
rail is of a heavy gauge. However, the
tabs can be created using the
appropriate tools.
6. Weld the tabs together along the
lower edges (2).
—continued
5mm
(0.25 in)
1
2
1
1
2