3-19
BIOS Setup
AC97 Modem
Auto allows the mainboard to detect whether a modem is used. If a mo-
dem is detected, the onboard AC’97 modem controller will be enabled;
if not, it is disabled. Disable the controller if you want to use other con-
troller cards to connect a modem. Settings: Auto, Disabled.
Onboard LAN Device (for 865PE)
This setting is used to enable/disable the onboard 10/100Mbps LAN
controller. Setting options: Disabled, Enabled.
Onboard 1394 Device (for 865PE)
This setting is used to enable/disable the onboard IEEE1394 controller.
Setting options: Disabled, Enabled.
Super IO Device
Press <Enter> to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) in-
stalled on the system board and you wish to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field. The
settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3,
Disabled, Auto.
