46 Storage Cradles
MX3X User’s Guide E-EQ-MX3XOGWW-N
Desktop Cradle for MX3X
Note: LXE recommends the correct Desktop Cradle always be used to store / charge /
communicate with the MX3X. The MX3X Desktop Cradle label is located on the bottom
of the device. The MX3X Desktop cradle Product Number is MX3002DSKCRDL.
Lower the mobile device straight into the cradle, tilt it forward and then let it rest backward in the
cradle. Ensure that the mobile device is properly seated on the charging contacts. The CHGR LED
will illuminate green when the MX3X is correctly seated in the cradle. The CHGR LED will
illuminate red when the MX3X main battery is being charged (in a cradle connected to an external
power source). To remove the MX3X, tilt the MX3X forward and lift it straight up out of the
cradle.
Note: Do not "slam" or slide the mobile device sideways into the cradle. Damage may result.
Connectors
The Power connector is located on the back of the cradle in the top left hand corner. The cradle
can be powered, if required, by an LXE US AC Adapter or an LXE International AC Adapter.
When powered, the cradle transfers power to the internal charging circuitry of the MX3X allowing
it to recharge the main battery. A powered cradle supports RS-232 and IR communications.
The RS-232 connector is located in the back center of the cradle. When the MX3X is properly
docked, the bi-directional half-duplex transceivers in the MX3X and cradle are aligned through
their IR windows. The half-duplex IR signals from the MX3X are converted to RS-232 signals in
the cradle and available at this connector.
