Enter Data 25
E-EQ-MX3XOGWW-N MX3X User’s Guide
Using a Headset and Voice for Data Entry
Connecting the Audio Cable and a Headset
Note: The audio option draws power from the main battery. The speaker is disabled when a
headset is plugged into the audio jack.
The headset consists of an earpiece, a microphone and an attached cable. The headset attaches to
an audio cable which attaches to the MX3X. The audio jack is located on the MX3X endcap.
1
Quick
Disconnect
Connector
1
2
9000076CABLE
2
2.5mm
Connector
Figure 20 Audio Cable and Headset
Insert the 2.5mm barrel end of the connector into the audio jack on the endcap and push the
connector in firmly.
Align the audio cable quick disconnect end and the headset quick connect cable end. Firmly push
the cable ends together until they click and lock in place.
Adjust Microphone and Secure the Cable
Do not twist the microphone boom when adjusting the microphone.
The microphone should be adjusted to be about two finger widths from your mouth.
Make sure the microphone is pointed at your mouth. Note the small Talk label near the
mouthpiece. Make sure the Talk label is in front of your mouth.
The microphone cable can be routed over or under clothing.
Under Clothing
• Leave the cable exposed only at the top of the collar.
• Be sure to leave a small loop of cable to allow movement of your head.
Over Clothing
• Use clothing clips to hold the cable close to your body.
• Tuck the cable under the belt, but leave a small loop where it goes under the belt.
• Do not wear the cable on the front of your body. It may get in your way or get caught on
protruding objects.
