Air Shunt At |ustment
To adjust surface burner air
shutters:
Loosen fastening screw with a phillips screw
driver and rotate air shutter to increase or
decrease the size of the air opening. As the
shutter is turned observe change in flame
appearance. Adjustment is satisfactory
when a clearly defined, even blue flame
results at the Hi flame setting. After
adjustment, tighten screw.
"_ SURFACE BURNER ROTATE AI'_
"- AIR SHUTTER SHUTTER ON
MFXER HEAD TO
SCREW MAKE AIR
ADJUSTMENT
AIR SHUTTER
AIR ( TO
OPEN
To adjust grill burner air
shutters:
The left hand air shutter controls the rear
half of the grill burner. The right hand shutter
controls the front half.
Slide air shutter backward or forward to
increase or decrease the size of the air open-
ing. Air shutters fit snugly on the grill burner,
so a screwdriver blade may be required to
make this adjustment. Observe change in
flame appearance as the air shutter is moved.
Adjustment is satisfactory when a clearly
defined, even blue flame results at the Hi
flame setting. The snug fit of the air shutter
assures it will remain positioned correctly.
On any burner, closing the air shutter too
far will cause the flame to become soft and
yellow tipped. Opening the air shutter too
wide will cause the flame to blow away from
the burner ports. Proper adjustment will pro-
duce a sharp, clearly defined, even, blue
flame.
GRILL BURNER AIR SHUTTER
INSERT SCREWDRIVER 8LADE
IN SLOT AND TWIST WiTH
SLIGHT PRESSURE TO ALLOW
AIR SHUTTER TO SLIDE EASILY
Lo Flame Adjustment
This appliance has been shipped from the factory with Lo and Med flame settings
adjusted for use with natural gas and average installations. There is a wide variety
of conditions caused by altitude and gas mixtures controlled by utility companies,
which will vary and affect the gas flame and performance. Adjustments should be
made at time of installation. If conditions change, follow the procedures outlined
to adjust the Lo setting.
10
