194
Software Fixes in Release K.11.12 - K.13.49
Release K.13.17
A new configuration option provides the ability to configure which MACs a client is permitted
to use; Feedback information; and, SSH CLI show command information enhancements. For
more information, see “Release K.13.16 Enhancements” on page 94.
■ Config (PR_0000000741) — When the rate limit for broadcast or multicast inbound is set
to 0% (i.e. blocking all traffic), output from the CLI command show running config doesn’t
display any rate limit information. If the rate limit is set to 100% (i.e. allow all traffic – the
default), show running config shows that rate-limiting is set to 100%. The correct behavior
is for non-default values to be displayed in the configuration.
Release K.13.17
The following problems were resolved in release K.13.17 (not a public release).
■ RADIUS/Jumbo (PR_ 1000779048) — When an 802.1X enabled port belongs to a VLAN
that is jumbo enabled, the Access-Request will specify a value of Framed-MTU of 9182 bytes.
When the RADIUS server replies with a large frame, the switch does not respond, causing
the authentication process to halt.
■ Protocol Starvation (PR_0000003814) — If the switch is configured for routing, certain
packets may cause a packet buffer leak, resulting in some or all of the following symptoms:
• OSPF neighbor relationships and route information are lost
• PIM neighbor relationships are lost
• Telnet, Ping, and SNMP become unresponsive
Authorized Managers (PR_1000806039) — ProCurve Manager may delete Authorized
Managers that have been configured on the switch.
■ Crash (PR_0000001756) — Configuration of VLANs and VLAN port assignment using
SNMP may cause the switch may crash with a message similar to the following.
Software exception at bcmHwVlans.c:149 -- in 'mAdMgrCtrl', task ID
= 0x18636e8 -> ASIC call failed: Entry not found.
■ Crash (PR_1000715077) — When RADIUS Accounting is configured, the switch may crash
with a message similar to the following.
NMI event SW:IP=0x002bd6c4 MSR:0x00029210 LR:0x002bc6a8
Task='mAcctCtrl' Task ID=0x85e9f10 cr: 0x48000084 sp:0x085e9e38
xer:0x20000000
■ Static Route/Config (PR_0000003962) — Updating from K.13.03 - K.13.09 to K.13.10 -
K.13.16 can cause static routes configured with a VLAN as the next hop (vs. an IP address) do
not translate correctly.
