4.7 Using the Network Settings Menus
fi-6010N Network Scanner Operator's Guide 117
4
5. At "Split Mails", set whether to send split e-mails.
The default setting is [Off].
Press the [On] button to send split e-mails.
Press the [Off] button to send an e-mail without splitting it.
6. For "Segment Size", set a value from 64 to 10240 as the maximum size for splitting an
e-mail.
The default size is "256 KB".
7. Set the "Maximum Attachment Size" for e-mails (total data size when sending an e-
mail). This may be between 1 and 20 MB.
The default size is "10MB".
8. For "Address Warning Limit", set a value from 2 and 1000 as the maximum number of
addresses to which e-mail can be sent without confirmation. If the number of recipient
addresses specified for an e-mail is then larger than this value, a warning dialog will
be shown to prevent inadvertent transmission of a mass e-mailing.
The default value is "100".
9. Press the [OK] button.
The SMTP server is set.
Set this value so as not to exceed the value of the message size
restriction set in the SMTP server.
