It is possible to store up to 12 Sequences each of 250 steps. To select a different sequence
number use the Up or Down soft keys to select the sequence number you want. If the number
next to steps has a value other than 000 then it has already had memories stored in it. By
selecting a sequence that already has steps in it it is possible to add, delete or edit steps.
To program a new sequence press the soft key associated with Select. You now have two
options, Auto Seq or Steps.. If you use Auto Seq it will use all the recorded memories to make
up a chase starting with the first recorded memory and ending with the last.
If you select Steps you can make up your own sequence. Selecting Steps.. will take you to the
following screen:
Select Insert Step this will take you to the following screen:
Use the Page + or Page – keys to take you to the page that the memory you want is on. Select
the memory by pushing the flash button the memory is stored on. Flash buttons that have
memories stored on them will have the Yellow LED lit. Each time you press a flash button the
number of steps will increment by 1. You will see the change in the top right hand corner of the
LCD display. To preview memory you are about to add as a step raise the fader. This will output
the memory.
Once you have set the number of steps you require use the Back key twice to take you to the
save menu page.
From this page you can save the chase or if you do not want to keep it then you can use cancel.
You now need to use the Back key to go to the default menu page.
Program Sequence 01
Back (000 Steps)
Up
Down Select
Step 001 Seq05
Back
Insert Step
Page01 Step 001
Back
Page+
Page-
Program Sequence 01
Cancel Delete Seq
Save As Auto Seq
Save Steps..
