AZI Customer Service 800-528-7411 or 602-470-1414 Page 18 of 92
Move the selection box down to
REPORT START and press
[ENT]. Select between:
Test Start – begins to send
data at the start of the test,
First Prediction - begins to
send data as soon as the
instrument makes the first
prediction, or
Test End – waits to send data
until after the test is over and
then sends only the final results
of the test.
Press [ENT] to select your choice.
Move the selection box down to
REPORT INTERVAL and press
[ENT]. Select an interval that will
provide the test progress report
you need and press [ENT] again to
select your choice.
Move the selection box down to
INCLUDE GRAPH. Pressing
[ENT] will toggle between YES
and NO.
Select NO if you do not
need a printed graph of the
test.
Select YES if you have only
the parallel port selected and want to print the graphic plot of weight and
moisture/ash results for a test.
Press [ESC] to return to the REPORT SETUP MENU.
Select REPORT ITEMS TO PRINT. See page 52.
By default, all items are selected to print. If you do not want or need items, use the
arrow keys to select the item(s) and press [ENT] to toggle the check mark off. If
you later need the item, position the cursor in front of the item and press [ENT] to
toggle the check mark back on.
Press [PAGE 2] to see additional selections.
Press [ESC] until the Main Test Screen appears.
The output to the printer will be tested when a weight test is performed later. If you are
connecting a printer to an instrument that has been in operation, it is necessary to
1. Turn the MAX 5000XL OFF
2. Connect the printer to the MAX 5000XL.
3. Power ON the printer,
4. Turn the MAX 5000XL back ON to establish the communications.
5. Run a weight test and monitor the output to the printer.
