Filter
Top Products
English
22
Unpacking Your Washer
• Remove all packing materials. This includes the foam base and all adhesive tape
holding the washer accessories inside and outside. Slide out and remove bottom
styrofoam that is used to secure the washer from shipping damage due to
vibration and shock.
• Inspect and remove any remains of packing, tape or printed materials before
using the washer.
Leveling Your Washer
• Your washer has 4 leveling legs; which are located on the four bottom corners.
After properly placing your washer in its final position, you can level your washer.
• Leveling legs can be adjusted by turning them counterclockwise to raise your
washer or turning them clockwise to lower your washer.
Steps for Installation
Installation Pre-Requirement:
• Select a suitable location for the washer on a hard even surface away from direct
sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.
• Any floor unevenness should be corrected with the leveling legs located on the
bottom corners of the washer.
• The washer must be placed at room temperature. You must not place washer
where the temperature is at below freezing.