Summit SPW1200P Washer/Dryer User Manual


 
English
9
Filter
There are two lint filters in this washer as shown below.
First one is located inside the washer tub. There is a small nylon bag that will collect
lint and residue from dirty clothes during the wash cycle.
You must clean this lint filter after every load for the best results.
Pull up the filter to remove. Clean and slide back the filter to
replace.
The second one is located at the inner shaft of the agitator under the fabric softener
dispenser.
Remove inner shaft of the agitator out to clean the filter. You will see
that filter is located at the bottom of the shaft. The small nylon bag at
the bottom of the shaft will collect lint and residue from dirty clothes
during the wash cycle.
You must also clean this filter after every load for the best results. Press
both sides of filter clips to detach from the shaft. Clean and snap the
filter clips on to the shaft to attach it back.
Note: Do not wash your clothes without filters in their compartments inside the tub.
(lint filter)