Filter
Top Products
18
A. To clean the freezer parts, disassemble all parts.
(Refer to Sec. 3.11 - 3.17 for the disassembly of
freezer parts.)
B. Place all parts in warm, mild detergent water and
wash thoroughly. Rinse all parts with clean, hot
water. The use of soft water is recommended, along
with dishwashing detergents such as Joy, Dawn, or
equivalent.
NOTE
Take care not to damage parts by dropping or rough
handling.
C. Wash hopper (hopper models), feed tube (remote
models), and freezer barrel with warm detergent
water and brushes provided. Rinse with clean, hot
water.
NOTE
On remote models, feed tube must be cleaned from
top and from the inside of the barrel, using the 1-1/
2" x 30" brush provided.
D. Clean the rear seal surface from the inside of the
freezer barrel.
E. Remove the rear drip tray by opening access door on
side panel. Clean and replace drip tray.
3.20 SANITIZE FREEZER PARTS
A. Use a sanitizer mixed according to manufacturer's
instructions to provide a 100 parts per million strength
solution. Mix sanitizer in quantities of no less than 2
gallons (7.5 liters) of 120°F water. Allow the sanitizer
to contact the surfaces to be sanitized for 5 minutes.
Any sanitizer must be used only in accordance with
the manufacturer's instructions.
B. Place all parts in the sanitizing solution, then remove
and let air dry.
C. Assembly freezer parts. (Refer to Sections 3.12B -
3.13B for the assembly of freezer parts.)
NOTE
Any cleaning procedure must always be followed
by sanitizing the assembled freezer before filling with
mix.