Filter
Top Products
38
M412616
ELECTRICAL REQUIREMENTS
For 50 Pound (22 kg) Tumblers
ELECTRIC DRYING TUMBLERS
NOTE: DO NOT use aluminum wire.
ELECTRIC DRYING TUMBLERS
240 V, 3 Phase
50 Hz.
380 V, 3 Phase
50 Hz.
415 V, 3 Phase
50 Hz.
Minimum Wire Size 3 AWG (26.67 mm²) 6 AWG (13.32 mm²) 6 AWG (13.32 mm²)
AMP Rating 78 AMP 48 AMP 45 AMP
Circuit Breaker 80 AMP 50 AMP 50 AMP
Poles 3 3 3
Figure 13
GAS AND HIGH PRESSURE STEAM DRYING TUMBLERS
208V / 240 V
1 Phase, 50 Hz.
208 / 240 V
3 Phase, 50 Hz.
380 / 415 V
3 Phase, 50 Hz.
Minimum Wire Size 14 AWG (2.081 mm²) 14 AWG (2.081 mm²) 14 AWG (2.081 mm²)
Circuit Breaker 15 AMP 15 AMP 15 AMP
Poles 2 3 3
Figure 12
Figure 11
Heat Source Electrical Specs Wires Required and Terminal Block Connection
Non-Reversing Models
Gas & Steam 230/50/1 L1 L2 Ground to PE Busbar
Steam 380-415/50/3 L1 L2 L3 Ground to PE Busbar
Electric 230/50/1 L1 L2 Ground to PE Busbar
Electric 380-415/50/3 L1 L2 L3 Ground to PE Busbar
Reversing Models
Gas & Steam 230/50/1 L1 L2 Ground to PE Busbar
Gas & Steam 380-415/50/3 L1 L2 L3 Ground to PE Busbar
Electric 230/50/3 L1 L2 L3 Ground to PE Busbar
Electric 380-415/50/3 L1 L2 L3 Ground to PE Busbar
GAS AND HIGH PRESSURE STEAM DRYING TUMBLER
REQUIREMENTS