Smeg SLB12SB Washer User Manual


 


7KHPDFKLQHGRHVQRWVSLQ
The unbalanced load sensor has triggered because the washing is not
uniformly distributed inside the drum. If the washing is wet at the end of
the cycle, distribute it well inside the basket and repeat just the spin cycle.

'UDLQLQJ ZDWHU IURP WKH
GUXP
In the event of a power failure or a fault in the appliance, the water inside
the drum can be drained as described in paragraph 6.3

7KHZDVKLQJ KDVQRW EHHQ
FRUUHFWO\VSXQ
Large items have rolled up and are not uniformly distributed inside the
drum. Always wash large items together with small ones.

5HVLGXHV RI GHWHUJHQW RQ
WKHZDVKLQJ
Many phosphate-free detergents contain substances that are difficult to
dissolve in water.
Select the Rinse programme or brush the washing.

:DVKLQJUHVXOWVDUHXQVDW
LVIDFWRU\
- Too little detergent or an unsuitable detergent may have been
used.
- Stubborn stains were not pre-treated
- The wrong temperature was selected
- The drum was overloaded
(55256,*1$/6
In the event of faults, the machine will display an error code.
(UURUFRGH 3UREOHP
Door not closed properly. Close it.
Aquastop. Contact the nearest Service Centre after disconnecting the machine from
the electrical power supply and closing the water tap.
No water for washing. See point 2 on the troubleshooting table.
The water does not drain. See point 4 on the troubleshooting table.
For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing
the water tap.