'LVSOD\LQIRUPDWLRQ
When the machine is switched on, the display visualises
the duration (hours/minutes) and maximum spin speed
envisaged for the programme. These two parameters are
displayed alternatively for 3 seconds each, together with
their relative LED’s, until the selected programme starts.
$WWHQWLRQ
• The following partial washing programmes can be set
using the programmes knob:
-Rinse with additive
-Drain and spin
-Fabric softener
These partial programmes are inside the Cotton, Synthetics and Wool sectors, except for the drain and spin
programme (Drain .
• If the indicated temperature shows 0°, this means that the programme performs a cold wash cycle. The same
cold wash is also performed by the +DQGZDVKprogramme in the Wool sector.
• The fabric treatment labels show which washing temperature must be set.
• ,IYDULRXVJDUPHQWVLQWKHVDPHORDGUHTXLUHGLIIHUHQWZDVKLQJWHPSHUDWXUHVFKRRVHWKHORZHVWZDVK
LQJWHPSHUDWXUHRIDOO
• If the laundry is only slightly dirty and does not need the bleaching effect of high temperatures, DORZHUWHP
SHUDWXUHFDQEHFKRVHQWRVDYHSRZHUIn spite of the low temperature and consequent saving of electric-
ity, an automatic time control keeps the duration of the main washing unvaried compared with that of a high
temperature programme. It is therefore possible to successfully wash QRUPDOO\GLUW\ODXQGU\DWORZHUZDVK
LQJWHPSHUDWXUHVthan the maximum temperatures shown on the fabric care labels.
02',)<,1*67$57,1*3$5$0(7(56
63,163 (('
Press the select spin speed button ( ), the relative LED lights up and the display visualises the maximum speed
envisaged for the selected washing programme.
Press the button repeatedly. Speed decreases by 100 rpm every time until the spin cycle reaches 0 rpm and is
disabled.
237,216
Use the options buttons (indicated in chapter 4 – Description of controls, letter H) to enable machine options. A
selected option is highlighted by the option LED located above the button in question.
'(/$<('67$5721/<)2502'(/6)($785,1*7+,6)81&7,21
Press the delayed start button ( ). The relative LED located above the button lights up.
The display visualises the time remaining (hours/minutes) before the selected washing
programme starts: the display initially shows 0 hours 0 minutes for all programmes.
Press the button repeatedly. The Start delay increases by 30 minutes each time it is
pressed for the first 12 hours. After that it increases to 60 minutes up to 24 hours.
VHFRQGVVHFRQGV
While selecting the delayed start time,
you can reset the timer by pressing the
button for at least 3 seconds.