Filter
Top Products
67$57,1*7+(:$6+,1*352*5$00(
1. Before starting the selected programme, carefully close the door, open the water tap and add the detergent
and additive
2. Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the cy-
cle.
After starting, the display shows the time remaining until the end of the programme. The LED remains on
throughout the cycle.
If delayed starting has been set (only for models featuring this option), the display visualises the time remain-
ing before the cycle starts. When delayed starting is set, the relative LED flashes on and off.
,17(55837,1*25&+$1*,1*7+(:$6+,1*352*5$00(
The washing programme may be interrupted at any time while it is running:
1. press “Start/Pause” for approximately 3 seconds: the display alternates between STOP (for 1 second) and
three horizontal lines (for 1 second) and the Start/Pause LED flashes.
The programme can also be stopped by turning the programme/temperature selection knob while the cy-
cle is running.
2. If you wish to change the washing programme, simply select the new programme by turning the programme
knob without pausing the machine first. The new washing cycle will be performed starting from the beginning.
If the tub is already full of water, the new programme will omit the filling phase.
3. To resume the cycle, press Start-Pause again.
+($7,1*3+$6(
During the water heating phase of the washing cycle, the heating phase LED ( ) lights up. This lets you
know when the washing machine is consuming most power.
(1'2)352*5$00(
The washing programmes are automatically completed, the display shows END and the
“Time remaining” LED lights up.
7XUQWKHSURJUDPPHVNQREWR2))WRVZLWFKRIIWKHPDFKLQH
2. Open the door.
3. Remove the washing from the drum.
4. Leave the door ajar in order to allow the inside of the washing machine to dry.
7XUQRIIWKHZDWHUWDS
Example
Example