Filter
Top Products
65 66
T: 0800 0124 382 T: 0800 0124 382
MAINTENANCE
Cleaning the Pump Filter:
1
Before opening the filter cover, place a container under it, ready to collect any water left in
the Washer Dryer.
2
Place the corner of the liquid detergent level plate (or a similar item such as a screwdriver)
into the groove on the pump filter cover and pull forwards to remove the pump filter cover.
3
Gently unclip and pull out the black rubber hose. Pull off the cap and allow any water to
drain into the container.
4
Once the water has drained, push the cap back on the end of the hose and clip the hose
back into position.
3
Loosen the pump filter by turning anti-clockwise and remove by pulling. Wait for any water
to drain into the container.
Figure 25
a:
b:
3
Remove any foreign materials from the filter with a soft brush.
4
Move the pump by hand to check that it rotates freely.
5
Clean the pump with a soft brush.
After Cleaning:
1
Re-fit the filter by inserting it and turning clockwise.
2
Close the filter cover.
The use of detergent may cause residual build up in the detergent drawer over time. Remove the
drawer at regular intervals to clean the accumulated residue. To remove the detergent drawer:
1
Pull the drawer forwards until it is fully extended.
2
Press down on the release catch (fig 26) and pull the drawer from its housing.
3
Clean the drawer with water and a soft brush.
4
If there is any residue in the drawer housing, remove with a soft brush. Take care to prevent
any residue from dropping into the machine.
DETERGENT DRAWER