Filter
Top Products
BEFORE USE
˾
Please read all of the instructions for use and the Important
Safeguards carefully.
˾
Remove all packaging from the generator.
˾
The first time the steam generator is used, it is normal for a
small amount of smoke and a slight odor to be produced.
It will quickly disappear.
˾
When starting, and while it is being used, the electric pump
injects water into the boiler. It makes a noise but this is
normal. If you are pressing on the steam control button at
this time, you may lose a little steam for a few seconds.
HELPFUL HINTS
˾
Before using the generator for the first time or if you have
not used the steam function for a few minutes, press the
steam button several times in a row while holding the iron
away from your clothes. This will enable any cold water to
be removed from the steam connection cord.
˾
When ironing start with fabrics that require a low
temperature setting (
●) and finish with those which need
the highest temperature (
● ● ●).
˾
Mixed fiber fabrics should be ironed on the temperature
for the most delicate fabric. For example a shirt that is 60%
cotton and 40% polyester should be ironed at the (
●)
setting for synthetics.
˾
If spray starch is used, spray it onto the reverse side of the
garment. Allow starch to penetrate before ironing.
˾
For best results, use a mesh type ironing board to allow
excess steam to escape.
˾
For delicate fabrics, we recommend carrying out a test on
an unobtrusive area of the garment such as an inner seam.
FILLING THE WATER TANK
1. Place your steam generator on a stable, horizontal heat-
resistant surface.
2. Remove the water tank by pulling
the tabs upward (1).
3. Fill the water tank taking care not
to exceed the maximum level (2).
(1)
(2)