Filter
Top Products
A fault indicator light comes on but the wash programme
continues as normal.
What to do if . . . Possible cause Remedy
The Check drain light
flashes.
The drain outlet is
restricted.
Clean the fluff (drain) filter
and drain pump.
The Check inlet light
flashes.
The water inlet is re
-
stricted or the water
pressure is too low.
–
make sure the stopcock is
opened wide enough.
–
make sure the inlet hose is
not kinked.
The filter in the inlet
hose is dirty.
Clean the filter.
The Final spin indicator
light flashes in the
programme sequence dis-
play.
The final spin has
not taken place. The
machine detected
an imbalance.
– Loosen and re-distribute
the washing.
– Select the programme
Spin
or
Drain
.
– Take into account the spin
speed of the relevant
programme.
The Anti-crease/Finish in-
dicator light flashes in the
programme sequence dis
-
play.
The position of the programme selector was al-
tered after the start of the programme. Turn the
programme selector back to the programme previ
-
ously chosen.
Problem solving guide
42