Filter
Top Products
Before using the machine for the first
time ensure that it is correctly in
-
stalled and connected. See the rele
-
vant section under "Installation".
Also check that the fluff filter is se
-
curely tightened to prevent the risk
of water leaks during use.
For safety reasons spinning is not pos
-
sible until the machine has been pre
-
pared for using for the first time. To acti
-
vate the spinning function you must run
a wash programme without laundry.
This also activates the ball valve. The
ball valve prevents detergent escaping
from the suds container into the sump
during a programme, thus making max-
imum use of the detergent.
Proceed as follows:
^ Open the stopcock
^ Do not load any laundry
^ Add max.
1
/
4
of the amount of deter-
gent you would use for a full load to
compartment j
^
Press the I-ON/O-OFF button in
^
Press the
Cottons
programme touch
pad
^
Use the $& touch pads to select a
temperature of 60°C
Important
This temperature is required to prepare
the machine for operation.
^
Press the
Water plus
touch pad
The indicator light will come on
^
Use the $& touch pads to set the
spin speed selector to
Without final spin
.
^
Press the START touch pad
^
Any residues in the machine will be
flushed out by the end of the
programme and your machine is now
ready for use.
Water hardness reminder
The amount of detergent required will
depend on various factors including
water hardness. The dial in the deter
-
gent dispenser can be set as a water
hardness reminder.
^ Remove the yellow lever from behind
the detergent drawer facia panel.
^
Use it to turn the dial to the position
which represents your water hard
-
ness level.
Your local water authority can advise on
water hardness in your area.
Before using for the first time
12