Filter
Top Products
The wash programme stops and a fault indicator light comes
on.
Fault indicator Possible cause Remedy A
The buzzer sounds and
the Check drain light
flashes. "– – –" appears
in the display.
The water outlet is
blocked.
Clean the fluff filter and the
drain pump as described in
"Problem solving guide -
Opening the door in the event
of a blocked drain outlet
and/or power failure".
The drain hose has
been fixed too high.
The maximum drain height is
1 m.
The buzzer sounds and
the Check inlet light
flashes. "– – –" appears
in the display.
The water inlet is
blocked.
Open the stopcock.
The buzzer sounds and
the Check inlet and
Check drain lights flash.
"– – –" appears in the
display.
The Waterproof
system has reacted.
Call the Service Department.
The buzzer sounds and
the Soak/Pre-wash or
Rinses indicator light
flashes in the
programme sequence
display. "– – –" appears
in the display.
There is a fault. Start the programme again.
If the fault indicator occurs
again, contact the Service
Department.
ATo switch off the fault indicator: switch the washing machine off with the
I-ON/0-OFF button and turn the programme selector to
Finish
.
Problem solving guide
41