Filter
Top Products
A fault indicator light comes on but the wash programme
continues as normal.
Problem Possible cause Remedy A
The Check drain light
flashes.
The drain outlet is
restricted.
Clean the drain filter and the drain
pump as described in "Problem
solving guide - Opening the drum
door in the event of a blocked
drain outlet and/or power failure".
The Check inlet light
flashes.
The water inlet is
restricted.
Check whether
–
the stopcock is opened wide
enough.
– the inlet hose is kinked.
The filter in the
water inlet hose is
dirty.
Clean the filter.
The Excess detergent
check light comes on.
Excessive foam
has built up
during washing.
Use less detergent next time and
follow the manufacturer’s
instructions on dosage given on
the packaging.
The Main wash
indicator light is
flashing.
There is a fault. Start the programme again.
If the fault indicator occurs again,
contact the Service Department.
The Anti-crease/Finish
indicator light is
flashing.
The position of the programme selector was altered
after the start of the programme. Turn the programme
selector back to the programme previously chosen.
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off
button and turn the programme selector to
Finish
.
Problem solving guide
37