Filter
Top Products
I Adding detergent
It is important to dispense the correct
amount, because. . .
. . . too little detergent results in:
–
Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
–
Greasy particles cling to the laundry.
–
Limescale deposits on the heater
elements.
. . . too much detergent results in:
– Excessive foam, which causes a low
level of agitation and poor wash,
rinse and spin results.
– higher water consumption because
an extra rinse is automatically
activated
– A burden to the environment.
^
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i = Pre-wash
(if selected, add
1
/
4
of the
total amount recommended for
the programme). This compart-
ment is also used for starch
formulations when starching
separately.
j = Main wash
including the Soak period if
selected
§ = Fabric conditioner or
liquid starch.
^
Close the detergent drawer.
See section on "Detergent" for further
information on detergent and the
amount to dispense.
J Press the Start button
This starts the programme. The
maximum programme duration will then
show in the display.
Garment care label symbols
24