Filter
Top Products
The wash programme stops and a fault indicator light comes
on.
What to do if . . . Possible cause Remedy
The Check drain indica
-
tor light is flashing.
The water outlet is
blocked.
Clean the fluff (drain) filter
and drain pump.
The drain hose has
been fixed too high.
The maximum drain height
is 1 m.
The Check inlet indicator
light is flashing.
The water inlet is
blocked
–
Open the stopcock.
–
Start the programme
again.
One of the following indi-
cator lights is flashing:
– Soak/Pre-wash
– Main wash
– Rinses
– Rinse hold
There is a fault. – Press I-ON/0-OFF button
to release it.
– Turn the programme se-
lector to
Finish
.
– Press I-ON/0-OFF button
in.
– Re-start the programme.
– If the fault indicators oc-
cur again, contact the
Service Department.
Problem solving guide
45